Sena PS810 Bedienungsanleitung PDF herunterladen (Seite 63)

Figure 4-14 Serial communication type and DIP switch configuration. (PS110/410)

For more information about pin out of serial port and wiring diagram, please refer to Appendix 1.

Connections section.

Note:

1. Please turn off the power of the Pro Series device before changing the position of DIP switch in

case of PS110/410. Changing the position of DIP switch while the power is on may cause

damage to the device.

(If the DIP switches are set incorrectly, the PS110/410 will display “Invalid” for the UART type on

the UI as shown on Figure 4-15, which will hinder communications to the serial port.)

2. In case of PS810, UART type can be changed by software through configuration only. So

PS810 does not have a DIP switch for changing UART type.

Figure 4-15 Invalid UART type settings displayed on the Serial port configuration main screen

 Baud rate

The valid baud rate for the Pro Series is as follows:

75, 150, 200, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, and 230400

The factory default setting is 9600.

 Data bits

Data bits can be between 7 bits and 8 bits. The factory default setting is 8 bits.

 Parity

Parity can be none, even or odd. The factory default setting is none.

 Stop bits

Stop bits can be between 1 bit and 2 bits. The factory default setting is 1 bit.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 109 110

Keine Kommentare

Sena PS810 Bedienungsanleitung Seite 63